WAN Configuration
To configure the WAN interface, enter the appropriate ATM PVC or use the check box to select WAN service over (eth0) interface. Note, before you select WAN service over (eth0) interface, you must erase all existing ATM PVC configuration. Also, once you select WAN service over (eth0), you cannot configure any other ATM PVCs until the WAN service over Ethernet entry is deleted.

ATM PVC Configuration
This screen allows you to configure an ATM PVC identifier (PORT and VPI and VCI) and select a service category. Otherwise choose an existing interface by selecting the checkbox to enable it.

PORT: [0-3]
VPI: [0-255]	يجب وضع هذه القيمة هنا
VCI: [32-65535]	يجب وضع هذه القيمة هنا

VLAN Mux - Enable Multiple Protocols Over a Single PVC

802.1Q VLAN ID: [0-4095]

Service Category:

UBR Without PCR UBR With PCR CBR Non Realtime VBR Realtime VBR

Peak Cell Rate: [cells/s]

Sustainable Cell Rate: [cells/s]
Maximum Burst Size: [cells]

Enable Quality Of Service

Enabling packet level QoS for a PVC improves performance for selected classes of applications.  QoS cannot be set for CBR and Realtime VBR.  QoS consumes system resources; therefore the number of PVCs will be reduced. Use Advanced Setup/Quality of Service to assign priorities for the applications.

Enable Quality Of Service